Enamelling machine with the characteristics of high output, low
power-consumption, stable quality control
Enameling Machine SPECIFICATION
I. Technical specification of equipment
1. Wire rangeΦ0.08Φ0.25mm
2. Mechanical speed310m/min (max)
3. Wire pitch7mm
4. Enamel application method Felt
5. No. of passes per line 8
6. No. of line 24
7. Take up methodSemi-automatic spool changeover
8. Suitable take-up spoolPT4-PT25
9. Suitable pay off spoolΦ240Φ300
10. Installed electric power115KW
II. Component of equipment parts
The plant consists of pay off device (dynamic model & platform
model), softening oven, fore and rear stand of sheaves, hot air
circulation oven, take-up device and electric control board etc.
1.1 Φ240-Φ300 iron spool, damping wisk type pay off device was
1.2 Platform model with water cleaning device.
2. Softening oven
2.1 Slant water seal with steam protection were adopted to prevent
oxidation of copper wire and has blow-drying and baking device.
2.2 The effective length of softening oven is 5400mm, 28 stainless
steel pipes (Φ14×2), its maximum temperature is 650.
2.3 One set of steam generator with electric heating fitted with
alarm of low water level.
2.4 PID temperature control instrument was adopted for softening
oven; the control is divided into two points (at fore and rear).
2.5 Separate left and right controls were used for speed-assisting
device of wire inlet of softener.
Rod Breakdown Machine
Intermediate Wire Drawing Machine
Fine Wire Drawing Machine
Double Twist Bunching Machine
Continuous Annealing Tin-Coating Machine
Wire drawing dies